BSIDE ADMS1A Intelligent Digital Multimeter Lcd Non-contact Voltage Tester Pen

2.4-inch screen: large 2.4-inch LCD greatly enhances the test and reading experience.

8 LED indicators: 8 LED indicators, 3 colors, very easy to judge the detected voltage intensity.

Live line inspection: according to the detected voltage strength, it is safe and convenient to check the live / neutral line.

Breakpoint location: without cutting off the wire, the breakpoint of live wire can be quickly located according to the detected voltage strength.

Description：
Product Category:intelligent digital multimeter
The maximum voltage allowed by the measuring terminal: 400V DC or 400V AC (effective value)
Working height: up to 2000m
Display: LCD
Maximum display value: 2000 digits.
Polarity indication: automatic indication,'-' means negative polarity.
Over-range display:'OL'’ or'-OL'.
Sampling rate: about 3 times per second.
Unit display: with function and power unit display.
Automatic shutdown time: about 2 minutes.
Battery undervoltage indication: LCD display port symbol.
Temperature coefficient: less than 0.1x accuracy/°C
Operating temperature and humidity: 0~40°C (<80% RH, not considered when <10*C)
Storage temperature and humidity: -10~60°C (<70% RH, remove the battery)
Size: 150x39x 18mm
Weight: about 65g (without battery)
product description:
 The meter complies with the general technical requirements of GB/T 13978-92 digital multimeter and complies with GB4793.1-1995
(IEC-61010-1) The safety requirements for electronic measuring instruments are classified as secondary pollution, and the overvoltage standard is CAT II 400V.
Content：
1 * intelligent digital multimeter
2 * Test Leads
1 * silicone rope
1 * user manual
Note:
1. When using, the correct function and range must be used
2. When using the meter, the user must abide by the standard safety rules
-Universal protection against electric shock
-Prevent misuse of the meter
3. When the meter is connected to the measuring circuit, do not touch the top of the test lead (metal part)
4. When measuring, if the measured voltage is higher than 60VDC or 30V AC (effective value)
Be careful to keep your fingers always behind the finger guard of the test lead
5. If the voltage of the measuring terminal exceeds 400VDC or 400VAC, do not measure the voltage
6. Do not measure resistance and circuit continuity with electricity.
7. In the resistance and line continuity test range, care should be taken to avoid connecting the meter to a voltage source
8. Do not use the meter near explosive gas, steam or dust
9. If you notice any abnormality or malfunction of the meter, you should stop using it
10. The meter should not be used unless the meter bottom case and battery cover are fully fastened in place
11. Do not store or use the meter under direct sunlight, high temperature, and high humidity