Radiolink R6DS 2.4G 6CH PPM PWM SBUS Output Receiver Compatible AT9 AT10 Transmitter as shown

--DSSS&FHSS act perfect on anti interference, especially on 433 and graph transmission.

Output SBUS, PPM and PWM signals simultaneously. Top speed response, 3ms for all channels parallel.

Sub miniature size, totally weights 3.4 grams, never burden to your drones, best choice for light drones.

Specially used for light drones, compatible with all flight controllers such as DJI NAZA, ZERO TECH, PIX, APM, MINI APM, NAZE32, and CC3D.

Description:

Item Name: Radiolink R6DS receiver

Band: 2.4G

Channel: 6 (Red LED indicator is for PWM mode. Blue LED for PPM, can be extended to 10channels)

Power Input: MAX 6V

Control Distance: 600m in air

Current Consumption: 38-45mA (Input voltage:5V)

Dimension: 25×16×11mm

Weight: 3.9g

Precision: 4096

Receiver Operation:

SBUS/PPM and PWM signal change

Short press the ID SET switch two times within 1 second, the signal is changed from normal PWM to SBUS/PPM. The red LED indicates the normal PWM and blue/purple indicates SBUS/PPM.

Installment of receiver antenna

The antenna must be kept as straight as possible. Otherwise it will reduce the effective range.

Large model aircraft may of some metal part interfering signal; in this case the antennas should be placed at both sides of the model. Then the best RF signal condition is obtained at any flying attitude.

The antennas must be kept away from conductive materials, such as metal and carbon by at least a half inch. The coaxial part of the antennas does not need to follow these guidelines, but do not bend it in a small radius.

Keep the antennas away from the motor, ESC, and other noise sources as much as possible.

Press and hold the Easy Link (ID SET) one second, now the receiver starts work.

After all of the above steps finished, the LED indicator will turn and keep in red.  

The receiver can be packed by sponge or foam for shocking proof when it is installed to the model.

Packing List:

1x Radiolink R6DS receiver

The different screens can cause the color of the item in the image to be a little different from the actual one. The allowed measurement error is +/- 1-3 cm.